IMPROVING MACHINING ACCURACY ON CNC MACHINE TOOLS THROUGH CAM-BASED THERMAL DEFORMATION COMPENSATION

Authors
  • Usmonov Javohir Valijon o’g’li

    Tashkent State Technical University, Tashkent, Uzbekistan

    Author

Keywords:
Array
Abstract

Thermal deformation causes a large share of the dimensional error of CNC machine tools, often cited as 40–70%. This paper proposes compensating it at the CAM stage: a thermal model predicts the spindle’s growth, and the CAM post-processor writes the correction into the NC program as a work-offset update. A worked example shows a 23.8 µm spindle elongation after 30 minutes, corrected by a G54 Z-offset change of +0.0238 mm.

References

Bryan, J. (1990). International status of thermal error research. CIRP Annals, 39(2), 645–656.

Mayr, J., et al. (2012). Thermal issues in machine tools. CIRP Annals, 61(2), 771–791.

ISO 230-3:2020. Test code for machine tools — Part 3: Determination of thermal effects.

ISO 286-1:2010. ISO code system for tolerances on linear sizes — Part 1.

Cover Image
Downloads
Published
2026-10-12
Section
Articles